18
• I have enabled a wireless MAC filter
(wireless access control - ACL) on my router. What
should I do when installing the WN1000RP?
The wireless device MAC address is translated to another
MAC address when the wireless device connects to the
WN1000RP. If your router MAC filter is enabled, the wireless
device will not be able to get the IP address from the
WN1000RP. To allow this wireless device to access the
Internet, you must add the translated MAC address to the
router.
To get the translated MAC address:
1. Disable the MAC filter on your router.
2. Power on the WN1000RP and connect all of your wireless
devices to the WN1000RP.
To Next Page
Loading...
