7
Option 1: Connect with WPS (Wi-Fi Protected Setup)
1. Press the WPS button on the WiFi Booster.
2. Within two minutes, press the WPS button on your wireless
router, gateway, or access point.
At this point, the WiFi Booster should be connected to
your existing WiFi network, and the Link Rate LED on
your WiFi Booster lights.
3. The WiFi Booster’s wireless network name (SSID) changes to
your existing WiFi network name, with _EXT at the end of the
name.
For example
:
4. Now connect your existing WiFi devices to the new WiFi Booster
network (MyNetworkName_EXT). Use the same network
security key (passphrase) as is set on your existing WiFi
network/WiFi router.
Existing WiFi network name: MyNetworkName
New WiFi Booster network name: MyNetworkName_EXT
To Next Page
Loading...
