6
Install the Extender
Place the extender, apply power, and connect it to your WiFi network.
Place the Extender and Apply Power
1. Place your extender in the same room as your WiFi router.
Note: Proximity to the WiFi router is required only during the
initial setup process.
2. Plug the extender into an electrical outlet.
The Status LED lights green. If the Status LED does not
light, press the Power button.
Connect to an Existing WiFi Network
To extend the range of your WiFi network, you must connect the
extender to your existing WiFi network. You can do this in one of two
ways:
• Connect with WPS. For more information, see Connect with
WPS on page 7.
• Connect with the genie Smart Setup. For more information,
see Connect with NETGEAR genie Smart Setup on page 9.
To Next Page
Loading...
