Need help?Do you have a question about the NETGEAR WN2000RPTv3 and is the answer not in the manual?
General| Device Type | Range Extender |
|---|---|
| Wireless Standards | IEEE 802.11b/g/n |
| Frequency Band | 2.4 GHz |
| Maximum Wireless Speed | 300 Mbps |
| Security | WEP, WPA, WPA2 |
| WPS Support | Yes |
| Ports | 1 x 10/100 Mbps Ethernet |
| Button | WPS Button |
| LED Indicators | Power, Ethernet, Wireless, WPS |
| Weight | 0.13 kg (0.29 lb) |
| Power Adapter | Input: 100-240V AC, 50/60Hz |
| Antennas | 2 x Internal |
Guides through the physical setup and initial connection of the extender to your WiFi network.
Explains how to configure the extender as a WiFi access point using a wired Ethernet connection.
Provides instructions for using the Smart Setup wizard for easy extender configuration.
Describes how to block specific devices from accessing the network using MAC addresses.
Instructions for modifying the login credentials used to access the extender's interface.
Steps to recover lost login credentials using configured security questions.
How to reset the extender to its original factory default state using the reset button.
Steps to check for and install new firmware updates for the extender.
Troubleshooting steps for resolving issues that prevent connection to the extender.
Solutions for problems encountered when trying to connect the extender to a WiFi network.
To Next Page
