NETGEAR WN2000RPTv3 - Use the Extender in Access Point Mode

13
Use the Extender in Access Point Mode
You can use the extender as a WiFi access point, which creates a new WiFi
hotspot by using a wired Ethernet connection.
1. Use an Ethernet cable to connect the Ethernet port on the extender
to an Ethernet LAN port on a router or a remote Ethernet LAN jack
with LAN access.
2. Connect the power adapter to the extender and plug the power
adapter into an electrical outlet. Wait for the Status LED to light
green.
3. If the Status LED does not light, press the Power On/Off button.
4. Use a WiFi network manager on a computer or WiFi device to find and
connect to the NETGEAR_EXT (SSID) WiFi network.
Aer the connection with the computer or WiFi device is established,
the Client Link LED lights.
Extender
Router