18
I enabled a wireless MAC filter, wireless access control, or access
list (ACL) on my router. What should I do when installing the
extender?
When the WiFi device connects through the extender to your router,
the MAC address of the WiFi device shown on the router is translated to
another MAC address. If your router’s MAC filter, wireless access control,
or ACL is enabled, the WiFi device connects to the extender but cannot
get an IP address from the extender and cannot access the Internet.
To allow the WiFi device to receive an IP address from the extender and
access the Internet, you must provide the translated MAC address to the
router.
1. Log in to your router and disable the MAC filter, wireless access
control, or ACL.
For more information about how to disable your router’s MAC filter,
wireless access control, or ACL, see your router’s documentation.
2. Power on the extender and connect all of your WiFi devices to the
extender network.
3. Make sure that the Link Rate LEDs remain lit.
4. Log in to your extender.
a. Launch a web browser.
b. Enter www.mywifiext.net in the address field of the browser.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
