Get Started and Connect to a WiFi Network
6
N600 WiFi USB Adapter
4. To accept the license agreement, select the I agree radio button and click the Next button.
A message displays asking you to wait while software is installed. After a few minutes,
NETGEAR genie prompts you to insert your adapter
.
5. Insert the adapter into a USB port on your computer with or without the USB cable and
plastic cradle.
Note: The USB cable and plastic cradle can extend the range of your adapter
and improve WiFi reception.
6. T
o use the adapter with the USB cable and plastic cradle, do the following:
a. Place a fastener on the back of the plastic cradle and place another fastener on your
computer
.
Make sure that the surfaces on which you are placing the fasteners are clean and dry.
b. Insert the adapter into the plastic cradle.
c. Connect the USB cable to the adapter
.
Note: NETGEAR recommends using the USB cable that is supplied in the
package. Do not use another USB cable to connect the adapter to the
USB port on your computer. Using another USB cable might affect the
performance and correct functioning of the adapter.
To Next Page
Loading...
Need help?
General