16 Manually Installing Your Router
Setting Up Your Router for Internet Access
When configuring your wireless router manually, you must log in to your wireless router to set it
up initially and to make any changes to your wireless router’s settings later.
To access the router:
1.
Type http://www.routerlogin.net in the address field of your browser, and then click Enter.
Figure 12
The factory default state is reset when you use the Restore Factory Settings button.
See “Restoring the Default Password and Configuration Settings” on page 39 for
more information.
You can enter either of these addresses to connect to your wireless router:
http://www.routerlogin.net or http://www.routerlogin.com.
WPS. The WPS button/light will not be lit unless you push it to enabl
Push ‘N’ Connect (WPS) security. See “Using Push 'N' Connect
(WPS) to Configure Your Wireless Network” on page 23.
Power. The power light should turn solid green. If it does not, see
“Checking Basic Router Functions” on page 30.
Wireless. The wireless light should be lit after turning on the
router.
Internet. The Internet port light should be lit. If it is not, make sure th
Ethernet cable is securely attached to the wireless router Internet por
and the modem, and that the modem is powered on.
LAN. A LAN light (1-4) should be lit for each connected computer on
your network. Green indicates that your computer is communicating
at 100 Mbps; amber indicates communication at 10 Mbps. If a LAN
light is not lit for each connected Ethernet cable, make sure that the
Ethernet cable from the computer to the router is securely attached
at both ends, and that the computer is turned on.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
