NETGEAR WNR2000 User Manual

Troubleshooting 31
If the error persists, you have a hardware problem and should contact technical support.
• Power Light Blinks Green Slowly and Continuously. The router firmware is corrupted.
To restore your firmware:
a. Make sure your PC is connected to your router and the router is powered on.
b. Insert the Resource CD that came with your router into your PC.
– The CD will automatically start and detect the language you are using on your PC.
Select a different language option, if you prefer.
– If the CD does not automatically start, browse the CD and double-click on .
c. Click Supporting Software, then Netgear Firmware Recovery Utility, and follow the
prompts for the recovery process.
d. After firmware recovery is complete, follow the prompts to restore your configuration
settings.
• Power Light Stays Amber. When the router is turned on, the Power light turns amber for
about 20 seconds and then turns green. If the light does not turn green, the router has a
problem.
If the Power light is still amber 1 minute after turning on power to the router:
a. Turn the power off and back on to see if the router recovers.
b. Clear the router’s configuration to factory defaults. This will set the router’s IP address to
192.168.1.1. This procedure is explained in “Restoring the Default Password and
Configuration Settings” on page 39.
If the error persists, you might have a hardware problem and should contact technical support.
• Internet Light Stays Amber. When the router is turned on, the Internet light turns amber for
about 20 seconds and then turns green. If the light does not turn green, the router has a
problem.
If the Internet light is still amber 1 minute after turning on power to the router:
a. The Internet is not accessible. Confirm that you have the correct internet setting.
b. Clear the router’s configuration to factory defaults. This will set the router’s IP address to
192.168.1.1. This procedure is explained in “Restoring the Default Password and
Configuration Settings” on page 39.
c. Turn the power off and back on to see if the router recovers.

NETGEAR WNR2000 Specifications

General

Rack mounting	No
xDSL connection	Yes
Dimensions (WxDxH)	177.5 x 130 x 35 mm
Maximum data transfer rate	0 Gbit/s
WLAN data transfer rates supported	300 Mbit/s
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Product color	Black
Wi-Fi standards	Wi-Fi 4 (802.11n)
Ethernet LAN (RJ-45) ports	4
Web-based management	-
Security algorithms	WPA, WPA2-PSK

Weight and Dimensions

Depth	132 mm
Width	48 mm
Height	108.7 mm
Weight	163 g