Netopia R2020 - Configured to Accept Incoming Dial-Up Connections

4. Configured to accept incoming dial-up connections
To configure the Netopia R2020 to accept incoming dial-up connections, you should use the
following configuration method:
■ To create one or more dial-in Connection Profiles for each dial-in user, see “Creating a
new Connection Profile” on page 7-2.
You do this using console-based management.
For instructions on using console-based management, see “Console-based
Management” on page 5-1
For instructions on creating a Connection Profile to dial out to an ISP or corporate site,
see “Easy Setup” on page 6-1.