NETSPA CLEANER - User Manual

Questions and Answers

L
Lindsey JohnsonJul 28, 2025
Why is my NETSPA Swimming Pool Cleaner not picking up debris?
- M
  Monique DavisJul 28, 2025
  If your NETSPA Swimming Pool Cleaner isn't picking up debris, it might be due to a few reasons. First, check the battery level and recharge it if necessary. A fully charged alkaline AA battery can run for 70-80 minutes, while a NI-MH AA battery lasts 45-60 minutes. Another cause may be that the impeller is jammed. Power off the cleaner and check the gap in the middle of the cleaner to see if the impeller is jammed. If the impeller jammed, see behind “how to clear the dirt on the impeller”. Finally, the filter bag might be full; detach the filter basket and filter bag, and clean them. If the impeller is broken, contact your dealer for a replacement.
K
Kellie HurstAug 3, 2025
What to do if garbage flows out from the rear filter bag of NETSPA Swimming Pool Cleaners?
- K
  Kevin GreenAug 3, 2025
  If garbage flows out from the rear filter bag of your NETSPA Swimming Pool Cleaner, the filter sock may be damaged. Replace it with a new one.
W
wrodriguezAug 9, 2025
Why is garbage flowing out from the transparent suction head part of my NETSPA Swimming Pool Cleaner?
- S
  Sarah WhiteAug 9, 2025
  If garbage is flowing out from the transparent suction head part of your NETSPA Swimming Pool Cleaner, it's likely that the soft rubber of the rear impeller is broken. The soft rubber of rear impeller is like a door in case the garbage in the filter bag will flow backwards into impeller and the cover of transparent suction head part.
J
John IrwinAug 15, 2025
What to do if NETSPA Swimming Pool Cleaner cannot be recharged?
- J
  Jeffrey GravesAug 15, 2025
  If your NETSPA Swimming Pool Cleaner cannot be recharged, the battery might be dead, so contact your dealer for a battery replacement. WARNING! When you replace NI-MH battery, please contact the local dealers to purchase the original NI-MH battery in case that the electric cleaner is destroyed. Alternatively, the charger could be faulty; contact your dealer for a proper transformer. WARNING! Using wrong charger will result in damaging the cleaner /battery and void the warranty.
R
Randy WeaverAug 21, 2025
How to fix a NETSPA Swimming Pool Cleaner handle/pole connector that cannot be secured?
- C
  Candice NicholsonAug 21, 2025
  If the handle/pole connector of your NETSPA Swimming Pool Cleaner cannot be secured in assembly, it's possible the side pin is broken. Use the new V-Shape clip.