SWITCH ON AND OFF
Fig.D
For your safety, this tool is equipped with a double switch system. This
system prevents starting the tool inadvertently and will only allow
operation while holding the tool with both hands.
Switching on
· Squeeze the front handle switch (1).
· Squeeze the front trigger switch (2).
Switching off
· Release the front handle switch (1) or the trigger switch (2).
Never attempt to lock a switch in the on position.
Battery Charging
Observe correct mains voltage: The voltage of the power source must
agree with the voltage specified on the nameplate of the unit.
Equipment marked with 230 V can also be connected to 220 V or 240
V.
The Li-ion battery is protected against deep discharging by the
“Electronic Cell Protection”. When the battery is empty, the machine is
switched off by means of a protective circuit: The inserted tool no longer
rotates.
To Next Page
Loading...
