WARNING: Do not continue to press the On/Off switch after the
machine has been automatically switched off. The battery can be
damaged.
The battery is supplied partially charged. To ensure full capacity of the
battery, completely charge the battery in the battery charger before
using your power tool for the first time.
A battery that is new or has not been used for a longer period does not
develop its full capacity until after approx. 5 charging/discharging
cycles.
When the machine cannot rotate while the On/Off switch is pressed,
then the battery does not have enough capacity and should be charged.
Plug the mains plug of the adaptor (1) into a socket outlet and the
adaptor plug (2) into the socket (4) on the charger station (3). At this
time, the battery charge-control indicator (6) lights up. Then insert the
battery pack into the charger station. The battery charge-control
indicator indicates the charging progress. The indicator lights up red
during the charge procedure. The battery is completely charged when
the indicator lights up green again.
Disconnect the battery charger from the mains supply when not
using it for longer periods.
Protect the battery charger against moisture!
To Next Page
Loading...
