A. Please check whether the black guide has fixed the label
(5) Q: Why the printer is skipping labels or continuously feeding?
The main reasons for this problem are the following. This behavior is usually after you change your
label type, size, or manufacturer.
A. NT-LP110A hasn’t recognize your label details [This is the most common reason]
Please re-run the automatic label identification so the printer can recognize your label.
How to make label identification
(1) Hold down the button on the top and release it after hearing one “Beep”
(2) To ensure that your device did not send any print instruction to the NT-LP110A, please disconnect
the USB cable, and then keep pressing the button on the top and release it after you heard two
“beep”
(3) NT-LP110A will move the label to recognize its gap size and other properties.After confirmation,
the indicator on the top will turn to green, and the gap position of the label will be located at the
sawtooth of the printer
(4) You can reconnect the USB cable for print -test.
To Next Page
Loading...
