To Next PageTo Next Page
Need help?Do you have a question about the network 600 and is the answer not in the manual?
General| Brand | network |
|---|---|
| Model | 600 |
| Category | Stereo System |
| Language | English |
Covers basic electrical and physical characteristics including semiconductors, power, weight, and dimensions.
Details audio performance metrics such as output power, THD, frequency response, and input sensitivity.
Specifies the tuning ranges for the LW, MW, and FM radio bands.
Lists performance parameters for the cassette deck, including wow/flutter and frequency response.
Ensure proper component placement to prevent accidental electrical shorts during servicing.
Always replace protective devices such as insulators and barriers after working on the unit.
Inspect wires, including the AC-cord, for frayed insulation and check across-line components.
Replace flameproof resistors and capacitors with exact same types to prevent fire hazards.
Perform an AC leakage test on exposed metallic parts after re-assembly for safety.
Provides steps for removing the cassette player module from the main unit.
Instructions detailing the process for detaching the turntable player assembly.
Guidance on separating the main chassis from the cabinet and other components.
Lists the necessary test equipment required for performing alignment procedures on the unit.
Diagram illustrating the specific adjustment points and test points for tuner alignment.
Procedure for aligning the FM Intermediate Frequency (IF) stage.
Steps for tuning the FM oscillator circuit for optimal performance.
Procedure for aligning the FM tracking across different frequencies.
Procedure for adjusting the FM stereo separation for optimal audio quality.
Procedure for aligning the AM Intermediate Frequency (IF) stage.
Steps for tuning the Medium Wave (MW) oscillator circuit.
Procedure for aligning the MW tracking across different frequencies.
Steps for tuning the Long Wave (LW) oscillator circuit.
Procedure for aligning the LW tracking across different frequencies.
Maintenance procedures for cleaning tape path components to ensure proper operation.
Method to demagnetize the tape head to prevent loss of high frequency response.
Conditions requiring tape head adjustment, such as replacement or poor performance.
Diagram showing the specific test points and adjustments for cassette alignment.
Procedure for adjusting the record/playback head for optimal audio performance.
Calibrating the Dolby noise reduction system level for accurate operation.
Setting the level meter for accurate indication during playback and recording.
Adjusting the bias frequency for optimal tape recording characteristics.
Aligning the bias trap circuit to minimize unwanted frequencies during recording.
Adjusting the 19kHz trap filter to prevent interference during FM stereo reception.
Calibrating the bias current for proper tape bias settings.
Adjusting the recording input sensitivity for optimal signal capture.
Equipment arrangement for R/P head and Dolby level adjustments.
Test setup diagram for bias frequency calibration procedures.
Equipment configuration required for bias current adjustment.
Test arrangement for calibrating recording sensitivity.
Schematic diagram of the primary printed wiring board (PWB).
Detailed circuit schematics for various sections and components of the unit.
Diagram detailing power supply connections and speaker outputs.
Wiring layout for internal electronic components within the unit.
Wiring details for various connectors and printed circuit boards (PCBs).
A detailed list of components for the cassette deck mechanism.
A comprehensive list of parts for the BSR-P207 turntable.
A list of components and parts related to the unit's cabinet.
List of major cabinet parts and sub-assemblies.
List of screws, knobs, and other smaller cabinet hardware.
List of components for the main printed wiring board (PWB).
Detailed list of resistors, including part numbers and descriptions.
Detailed list of capacitors, including part numbers and descriptions.
List of components for the cassette printed wiring board (PWB).
