5
3. DO NOT charge the tool battery in an air temperature below +40°F(+4℃), or above +105°F(+40°C).
This will prevent serious damage to the battery.
4. It is recommended to wait 15 minutes after charging before using the tool to avoid the possibility of the
tool overheating and damaging the battery.
5. If the battery does not charge properly:
a) Check to see if receptacle is connected to a light switch which turns power off when you turn out the
lights.
b) If charging problems persist, take the tool and charger to your local service center.
6. The power tool should be recharged when it fails to produce sufficient power on jobs which were easily
done previously. DO NOT CONTINUE to use the tool under these conditions in order to prevent damage
to the battery. Follow the charging procedure. You may also charge a partially charged tool whenever you
desire with no adverse effect on the battery or battery memory.
7. Under certain conditions, with the charger plugged into the power supply, the exposed charging
contacts inside the charger can be shorted by foreign material. Foreign materials of a conductive nature
such as, but not limited to, steel wool, aluminum foil, or any buildup of metallic or other appliance. particles
should be kept away from charger cavities. Unplug charger before attempting to clean tool.
8. Do not freeze or immerse charger in water or any other liquid.
GUARANTEE
• Keep tool clean unplug power cord from power source before cleaning
• This product is guaranteed in accordance with statutory/country-specific regulations; damage due to
normal wear and tear, overload or improper handling will be excluded from the guarantee
• In case of a complaint, send the tool or charger Un-dismantled together with proof of purchase to your
dealer or the nearest authorized service station
To Next Page
