EasyManua.ls Logo

Neue SFO2SS - Service and Installation Information; Service Data and Troubleshooting Support; Building-In and Installation Guidelines

Neue SFO2SS
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Problem Possible cause Remedy
The oven does not heat up. The fuse is released. Make sure that the fuse is the cause
of the malfunction. If the fuse relea-
ses again and again, contact a
qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
Steam and condensation settle on
the food and in the cavity of the
oven.
You left the dish in the oven for too
long.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
The display shows "12.00". There was a power cut. Reset the clock.
Service data
If you cannot find a solution to the problem yourself,
contact your dealer or an Authorised Service Centre.
The necessary data for the service centre is on the
rating plate. The rating plate is on the front frame of the
appliance cavity. Do not remove the rating plate from
the appliance cavity.
We recommend that you write the data here:
Model (MOD.) .........................................
Product number (PNC) .........................................
Serial number (S.N.) .........................................
Installation
Warning! Refer to Safety chapters.
Building In
min. 550
20
6
600
min. 560
2
591
594
114
19
21540
570
558
16

Related product manuals