EasyManua.ls Logo

Neurotech MediTens XP - Accessories; Accessory Usage and Care; Unit Settings; Program Selection and Functions

Neurotech MediTens XP
144 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
10.0 Accessories
Only electrodes specified by BMR Ltd for use with MediTens XP may be used. Using other electrodes and leads may degrade per-
formance levels.
Do not dispose of used electrodes and batteries in household rubbish or in an open flame; dispose of them in accordance with
regulations in your country.
Electrodes wear out over time: If they are dirty or no longer adhere properly, they need to be replaced. Replace the leads if the
sheathing is damaged and exposes the copper wire.
Repair, Service & Modification
Access to the interior is not required for maintenance purposes.
Repair, service and modifications may not be carried out by anyone other than qualified service personnel authorised by
BMR Ltd
Do not use the unit if it is defective. Please return it to neurotech. BMR Ltd will not accept any responsibility where the guidelines
and instructions are not followed.
10.1 Unit Settings
ACCESSORIES & UNIT SETTINGS
Your personal therapy program is program no.
When switched on this can always be seen on
the unit’s display!
Use the Burst function (8)
Yes No
(possible with programs 2, 3)
Use the Trigger function (8)
Yes No
(possible with programs 1, 4, 5)
Note: If the unit’s display shows a different program from the
one prescribed by the clinician when you switch it on, please
do the following:
1. Switch the unit off and on then again.
2.
Hold down “P” button
(for at least 3 seconds each time
you want to change the program) until the program
prescribed by the clinician appears again. (The programs
advance from 1 - 5 and not in reverse, 5 - 1)
3. Start the therapy
MediTens XP IM W Europe_Layout 1 01/12/2010 12:29 Page 20

Table of Contents

Related product manuals