5
How to turn stimulation ON and change programs
To turn stimulation ON, make sure your remote control is ON. Stimulation is ON unless it has
been turned OFF.
1. If the Simulator Level Indicator isn’t illuminated,
stimulation is OFF.
2. Press the Stimulation Start/Increase Button once
to turn stimulation ON to predetermined level.
• When stimulation is turned ON (after it was turned OFF),
your device will be on the starting level for the last
active program you used.
3. To change the program, press the Program Selection Button.
Press the Program Selection Button repeatedly until the
light is at the desired program number.
• Once your desired program is selected, don’t press
any buttons until the light stops blinking. You will hear
1 beep from your remote control, conrming your new
program setting.
4. Make sure the light above your program number is
brightly illuminated.
2
3
4
1
If your remote control beeps 3 times and the program indicator goes back to the
previous program, then your program wasn’t successfully changed.
Place your remote control closer to your trial device and repeat the previous steps.
For Trial Patients
(TSM3000/TSM3500)
How to Use Your Trial Device
Note
To Next Page
Loading...