New Holland 140TL - User Manual

Questions and Answers

L
laurenbranchAug 11, 2025
Why is the pump noisy on my New Holland 140TL?
- B
  Beth MccarthyAug 11, 2025
  If your New Holland Farm Equipment's pump is making excessive noise, several factors could be the cause. Start by checking the inlet line for restrictions or leaks, looking for air leaks, restrictions, or a collapsed hose. Tighten or replace the hose if necessary, and consider changing the filter. Also, ensure the oil level is adequate by adding oil as required. If the noise persists, the pump itself may be worn or damaged, requiring repair or replacement.
C
Courtney CamposAug 17, 2025
What to do if my New Holland 140TL loader chatters or vibrates when raising or lowering?
- A
  Amy BrownAug 17, 2025
  If the loader on your New Holland Farm Equipment chatters or vibrates when raising or lowering, it could be due to mechanical binding of pivot areas. Clean the pivot pins and grease them as recommended. An air leak in the inlet line could also be the cause, so check, tighten, or replace the inlet line. Additionally, air in the hydraulic system can lead to this issue, so cycle the lift cylinders and bucket cylinders. Finally, ensure the oil level is sufficient by adding oil as required.
M
Michael RoblesAug 22, 2025
How to prevent excessive wear on the bucket cutting edge of my New Holland 140TL?
- K
  Katherine AcostaAug 23, 2025
  Excessive wear on the bucket cutting edge of your New Holland Farm Equipment can occur if the bucket is riding on the cutting edge instead of the wear pads. To prevent this, use the boom "FLOAT" position or the bucket level indicator to ensure the bucket rides on the wear pads.
D
Deborah MartinezAug 28, 2025
Why do the bucket tines bend or break on my New Holland Farm Equipment?
- L
  lisadavilaAug 28, 2025
  Bucket tines on your New Holland Farm Equipment can bend or break if only a few tines are under the load. Make sure that three or more tines are under the load.
K
Kayla PooleNov 3, 2025
What to do if the loader is slow or will not lift and/or dump on my New Holland 140TL Farm Equipment?
- K
  Kenneth HodgeNov 4, 2025
  If the loader on your New Holland Farm Equipment is slow or won't lift and/or dump, several factors could be at play. The hydraulic oil might be too heavy, so consider changing to the proper oil, especially for cold weather. A plugged tractor hydraulic filter could be the culprit, requiring a replacement. Alternatively, the tractor hydraulic pump might be worn, necessitating repair or replacement. Check all hoses and tubes for leaks, damage, or restrictions, and replace any that are compromised. Faulty hydraulic quick couplers could also be the issue; inspect them for leaks, damage, or restrictions. Ensure the control valve shifts properly; if not, inspect, clean, repair, or replace it. Air in the hydraulic system can cause problems, so cycle the lift and bucket cylinders several times to ...