Need help?Do you have a question about the New Holland BigBaler PLUS and is the answer not in the manual?
General| Bale Size | 80 x 70 cm, 80 x 90 cm, 120 x 70 cm, 120 x 90 cm |
|---|---|
| Bale Weight | Up to 500 kg, Up to 600 kg, Up to 700 kg, Up to 900 kg (depending on model and crop) |
| Pickup Width | 2.35 m |
| Number of Twine | 6 |
| Power Requirement | 110 - 180 kW (150 - 245 hp) depending on model |
Step-by-step guide for removing and installing cutting knives.
Explanation of how the rotor cutter forces crop into the pre-compression chamber.
Explains the meaning of specific decals related to lock-out valves.
Details how individual knives are protected by overload springs.
Step-by-step guide for removing and installing rotor cutter knives.
Details the process for installing rotor cutter knives into the drawer.
Explains the function and adjustment of the stuffer trip sensitivity lever.
Describes the components and modes of the bale density control system.
Details how to use the automatic bale density control system.
Explains how to interpret knotter monitoring flags for operation status.
Lists malfunctions indicated by knotter monitoring flags staying down or up.
Describes issues with the retainer causing insufficient overlap in the knot.
Describes issues with the retainer causing too much overlap in the knot.
Explains issues caused by a loose billhook cam spring.
Explains issues caused by a tight billhook cam spring.
Details problems related to the twine finger not functioning correctly.
Describes issues where the needle fails to pick up the top twine correctly.
Explains issues arising from slackness in the upper twine tension.
Explains issues arising from slackness in the lower twine tension.
Describes problems caused by insufficient needle penetration into the knotter.
To Next Page