New Holland CR10.90 User Manual

Part number 47956065
2
nd
edition English
May 2016
Replaces part number 47869947
SERVICE MANUAL
CR8.90 / CR9.90 / CX8.90
Tier 4A
CR8.90 PIN 1946 and above, CR9.90 PIN 1947 and above,
CX8.90 PIN 1962 and above
CR10.90 / CX8.80
Tier 4B (final)
CR10.90 PIN 1947 and above, CX8.80 PIN 1957 and above
Combine
Printedin U.S.A.
© 2016 CNH Industrial Belgium N.V. All Rights Reserved.
NewHolland is a trademark registered in the United States and many other countries,
owned by or licensed to CNH Industrial N.V., its subsidiaries or affiliates.

New Holland CR10.90 Specifications

General

Category	Combine Harvester
Engine	FPT Cursor 13
Threshing System	Twin Rotor
Engine Type	Diesel
Displacement	12.9 L
Transmission	Variable speed, hydrostatic
Unloading Rate	100 L/s
Header Width	9.0 m
Cutting Width	9.0 m
Rotor Diameter	600 mm

Summary

Service Manual Introduction

Equipment Servicing Foreword

Provides important notices and guidelines for equipment servicing and adherence to procedures.

Safety Rules and Accident Prevention

Details essential safety regulations, accident prevention measures, and PPE usage.

Basic Repair and Maintenance Instructions

Covers fundamental procedures like shimming, seal installation, lubrication, and sealing compounds.

Torque Specifications for Connections

Presents detailed torque values for various metric and inch fasteners and hydraulic fittings.

Roller Chain Wear and Measurement

Explains how to measure chain wear, allowable elongation, and chain size standards.

Product Identification and Location Guide

Information on locating and understanding the Product Identification Number (PIN) plates.

Engine Service and Repair

Engine and Crankcase Section

Information pertaining to the engine assembly and its crankcase components.

Engine Removal Procedure

Step-by-step instructions for the safe removal of the engine from the combine.