To Next PageTo Next Page
Need help?Do you have a question about the New Holland L320 Tier 3 and is the answer not in the manual?
General| Engine Make | FPT |
|---|---|
| Hydraulic Pump Type | Gear |
| Emissions Compliance | Tier 3 |
| Rated Operating Capacity | 2, 000 lbs |
| Bucket Width | 68 in |
| Tipping Load | 4, 000 lbs |
Provides important notices and disclaimers regarding equipment servicing procedures and manufacturer responsibilities.
Outlines essential safety precautions for operating and servicing the machine to prevent personal injury.
Covers fundamental safety guidelines for machine operation, including hazard awareness and safe practices.
Explains measures to prevent fires and explosions caused by fuel, oil, electrical components, and flammable materials.
Describes the importance and safety considerations for the machine's protective structures (ROPS/FOPS/Cab).
Provides safety precautions specific to the operation and maintenance of this particular machine model.
Specifies minimum tightening torque values for standard metric non-flanged hardware components.
Explains how to identify metric and inch hardware grades and markings for proper selection.
Provides standard torque values and guidelines for various hydraulic connections, including O-ring boss types.
Details fundamental procedures for shop assembly, seal installation, and spare parts usage.
Step-by-step instructions for securing the loader arm and tilting the cab for service on radial lift models.
Step-by-step instructions for securing the loader arm and tilting the cab for service on vertical lift models.
Lists the fluid and lubricant capacities for various machine systems, including fuel, coolant, and hydraulics.
Guides on locating and recording machine model, PIN, and serial numbers for service and parts.
