SECTION 55 - ELECTRICAL SYSTEM
55-26
ENGINE PREHEAT
The EIC controls a timed pre-heat cold start aid to
assist in cold weather starting. The timed pre-heat
cycle will vary from 0 to 40 seconds automatically
based on engine coolant temperature. For additional
pre-heat if the loader does not start, turn the ignition
key to the “OFF” position. Then turn the ignition key
back to the “RUN” position again. This will restart the
preheat timed cycle.
AUTOMATIC SHUTDOWN
If either the engine oil pressure, or hydrostatic charge
pressure fall below certain limits, the EIC will remove
power from the fuel solenoid after 30 seconds,
stopping the engine.
If this condition occurs, turn off the ignition key.
Before unbuckling the seat belt, turn the ignition key
to the “ON” position and lower the boom and
attachment to the ground or rest the boom on the
boom lockpins. Turn the ignition key to the “OFF”
position.
The operator may immediately restart the engine
again. Should the function remain faulted, power will
again be removed from the fuel solenoid in another
30 seconds and the engine will again stop. During the
30-second alarm period, the “ENGINE STOP”
symbol will flash. If this condition continues, locate
the fault and repair.
IMPORTANT: Use caution when restarting the
loader because of the possibility of NO
LUBRICATING OILS for the engine and/or the
hydrostatic transmission. DO NOT restart the loader
more than once or operate the engine at high
speeds. Damage to the engine and/or transmissions
may occur. Contact your New Holland dealer for
assistance.
WARNING
When the engine stop symbol flashes for the
30-second period, immediately lower the boom
and move the loader to a non-traffic area for
problem evaluation.
If an alarm is caused by 3, 4, or 7, the CHARACTER
DISPLAY will change to show the numeric value of
the function that caused the alarm.
To Next Page
Loading...
Need help?
General
