New Holland TD 95D - Page 91

SECTION 3 -- FIELD OPERATIONS
3--25
Chain type stabilisers -- Fig. 31
Rotate the sleeve (1) to adjust the stabiliser length.
TRE0821A
1
31
Telescopic stabilisers -- Fig. 32-- 33
To adjust the stabiliser length, proceed as follows:
-- remove pin (1) to allow free lateral swing of the
arms (3);
-- adjust the opening of the arms (3) by positioning
the pin (2) in one of the free holes on the sleeve.
1
2
3
TRE0801A
32
NOTE: Adjust the lateral stabiliser struts, fig. 32, so
that the lateral movement of the lower links (1)
fig. 33, does not exceed 120 mm (4.72 in) each side.
NOTE: Limited free movement of the lower links (1)
fig. 33 can be obtained by connecting the retaining
pins through the slots (2) fig. 33. This is particularly
useful when working with wide implements (harrows,
cultivators, etc.).
1
2
TRE0016A
33