QUICK START GUIDE:
1
2
3 4
Remove packaging and carefully lay
the main unit on the floor near to a
desired power point - It is advised to
lift the unit between two people if the
weight of the unit is too heavy.
Check positioning of running belt and
ensure it is aligned as advised using
the Allen key provided. The orange
strips running parallel on the unit
should be equidistant from the edge
of the frame of the unit. (please see
belt alignment section).
Level surface – Ensure the unit lays
flat on the floor without any wobble
or instability. If this is the case,
flooring may be on level and will
require adjustment to the unit. On
the underside, screw/unscrew the 4
stopper feet in small increments to
suit any uneven surfaces. This should
be done with care when lifting the
unit and should never be completed
whilst plugged into a power source.
Using the screws provided, align the
tablet with the holes on the upper
part of the handle. Insert screws and
tighten using the Allen key. Ensure
the front lip is facing in the direction
of the running belt for correct
orientation.
Insert power cable into the unit and
plug into power point.
5
To Next Page
Loading...