New Wave Research Tempest - Chapter Five: Flashlamp Replacement Steps; Flashlamp Replacement Steps

Tempest Nd:YAG Laser Operator’s Manual
50
Figure 5-4. Pump Chamber Attachment Screws
5) Remove the pump chamber from the laser head and carefully place it
on a clean surface.
6) Remove the pump chamber end caps that secure the flashlamp within
the pump chamber, Figure 5-5.
Figure 5-5. Removal of Pump Chamber Assembly End Cap
7) Carefully straighten the lamp leads and remove the flash lamp from
the pump chamber. Note the position of the RED and BLACK lamp
leads.
8) Install the new flashlamp with the RED and BLACK leads on the
same side as the original lamp. Bend the lamp leads so that they are
perpendicular to the lamp.
Pump chamber
end cap screws
Pump
Chamber
Q-Switch