36
Venting
Propane Tank
(Not Supplied)
Propane Hose and
Regulator
(Supplied)
Non - combustible
Construction
Propane Gas Installation
Propane gas Cylinder Connections
Make sure the Propane gas cylinder valve is fully closed. It is possible for the valve to be open
without releasing gas but, as soon as you start connecting the regulator, gas will leak from the
connection.
Insert the regulator inlet into the cylinder valve and turn the black coupler nut clockwise until the
coupler nut is hand tight. Do not over-tighten this connection. See Figure 1 & 2.
To disconnect the coupler nut, rst make sure the main cylinder valve is turned o. Grasp the
coupler nut and turn counter clockwise. The inlet will then disengage.
Always leak-test the connection after relling or exchanging Propane gas cylinders. (See Leak
Testing Instructions.)
To Next Page