40
Leak Testing Instructions
STOP
Testing a Gas Leak
Ensure all control knobs are in the o position.
Turn on the fuel supply.
• For Propane gas turn the cylinder valve knob counter clockwise one full
rotation.
Brush or spray a half-and-half solution of liquid soap and water onto all joints and connections of
the regulator, hose, manifolds and valves.
Bubbles will indicate a gas leak. IMMEDIATELY turn o the gas supply.
See next page for “Fixing a Gas Leak
WARNING
This must be done before initial use, annually, and whenever any gas components
are replaced or serviced. Do not smoke while performing this test, and remove all
sources of ignition. See Leak Testing Diagram for areas to check. Never conduct a
leak test using re or ame. Sparks or open ames will result in a re or explosion,
damage to property, serious bodily injury, or death.
Leak Testing Diagram
Propane Gas
Spray
or
Brush
To Next Page