Newage PRM 301 - FORWARD; GENERAL INFORMATION; CLAIMS UNDER WARRANTY; SERVICE PARTS

FORWARD
This workshop manual has been prepared to assist the operator or user of
Newage PRM marine gearboxes and also to enable the skilled service engineer to
undertake more detailed maintenance and overhaul.
GENERAL INFORMATION
PRM hydraulic marine gearboxes will give trouble-free service provided they
are correctly installed, aligned and maintained. In the event of failure, the
engine distributor who supplied the gearbox, or the local dealer, should be
informed; where this is not possible, Newage Transmissions Limited, or the
distributor for the area, should be notified. In all communications, verbal
or otherwise, the model and serial number of the gearbox must be quoted in
order to ensure correct identification and supply of parts.
CLAIMS UNDER WARRANTY
Claims for replacement of parts under warranty must always be submitted to the
distributor who supplied the gearbox; if this is not possible, application may
be made to the nearest distributor or dealer, who must, however, be advised of
the supplier's name and address.
SERVICE PARTS
The comprehensive illustrated parts list gives full information and ordering
procedure.
IDENTIFICATION PLATE
Every PRM gearbox is fitted with an identification plate on the top half of
the gearcase before it leaves the factory; an example of such a plate is shown
below.
NEWAGE PRM
123456
3O1VR3
COVENTRY
Al234
USE RECOMMENDED LUBRICANTS ONLY
NEWAGE PRM
COVENTRY
USE RECOMMENDED LUBRICANTS ONLY
Please complete the above box with
serial number and specification of
your own gearbox.
1