NewAir AI-215 Series Owners Manual & Instruction Guide

10
NEWAIR AI-215 SERIES PORTABLE ICE MAKER
Problem
Possible Cause
Solution
The “ICE BUCKET FULL”
indicator light is on.
The ice basket is full.
Remove ice from the
basket.
The “WARNING”
indicator light is on.
Ice shovel cannot
rotate
Check if ice cubes are
blocking the ice shovel;
otherwise, consult a
certified technician to
check the motor and
microswitch.
The “WARNING”
indicator flashes for 20
seconds when starting
or during operation.
Ice-full detecting
sensor on the edge of
interior tank is
malfunctioning.
Consult a qualified
technician to check the
sensor or change to a
new one.
Ice cubes stick together.
The ice cycle is too
long.
Stop the ice makerand
allow ice block to melt.
Select smaller size and
restart.
Water temperature in
inner tank is too low.
Change the water in the
inner tank. Temperature
of water is best between
45°F - 90°F.
The ice making cycle
appears to be normal
but no ice is being
produced.
The refrigerant may be
leaking.
Consult a qualified
technician.
A pipe in the cooling
system may be
blocked.
Consult a qualified
technician.
Ambient temperature
or water temperature
in inner tank is too
high.
Please run the ice maker
below 90°F and pour
colder water into the
tank.
The ice cubes are too
small.
The ambient
temperature or water
temperature may be
too high.
Select large sized ice
cubes by pressing the
“SELECT” button.
The compressor may
need to warm up.
If this is the first time the
unit is being used, allow
the ice maker to cycle a
few times. This should
result in larger cubes.

NewAir AI-215 Series Specifications

General

Brand	NewAir
Model	AI-215 Series
Category	Ice Maker
Language	English