NewAir NIM040SS00 - User Manual

Questions and Answers

S
Sandra MackAug 4, 2025
What to do if NewAir NIM040SS00 Ice Maker cycle is normal but there is no ice?
- L
  Lisa MunozAug 4, 2025
  If your NewAir Ice Maker is running its cycle normally but not producing ice, the ambient or water temperature may be too high. Try to keep the ice maker away from heat sources, ensuring it's not near 90 degrees, and fill the tank with cold water. Alternatively, there could be a refrigerant liquid leakage or a blockage in the cooling system pipe, in which case you should contact customer service.
G
gutierrezjosephAug 9, 2025
How to fix “Add Water” indicator on NewAir NIM040SS00 Ice Maker?
- G
  Gloria AlvaradoAug 10, 2025
  If the “Add Water” indicator is on for your NewAir Ice Maker, it means the water level is low. Turn the unit off, fill the water tank, and then turn the unit back on.
D
Devin PachecoAug 16, 2025
What to do if the “Ice Full” indicator is on for NewAir NIM040SS00?
- K
  kenneth98Aug 16, 2025
  If the "Ice Full" indicator is illuminated on your NewAir Ice Maker, it could be due to several reasons. First, the ice basket may be full, in which case you should remove the ice. Second, the ice sensor might be broken; try turning the unit off and on again to see if ice production restarts, and if not, contact customer service. Third, the ice scoop might be stuck and blocking the sensor; check and rearrange the scoop if necessary.
M
Matthew LongAug 22, 2025
Why is the “Ice Full” light off on my NewAir NIM040SS00?
- K
  kimberly31Aug 22, 2025
  If your NewAir Ice Maker is making ice, but the light is off, it might be because the unit is too close to a light source, affecting the infrared detection. Try moving the ice maker to a darker location.
D
Dennis JohnsonAug 28, 2025
Why do ice cubes stick together in my NewAir NIM040SS00 Ice Maker?
- J
  John LewisAug 28, 2025
  If the ice cubes from your NewAir Ice Maker are sticking together, it could be because the ice-making cycle is too long. Stop the ice maker and restart it after the current ice blocks melt and fall off. If that doesn't work, the water temperature in the inner tank may be too high, so try using colder water to fill the tank. It could also be that part of the evaporator rods in the ice box are too large, so try changing the water in the reservoir.