NewAir NIM026MBN0 User Manual

EN
www.newair.com 12
TROUBLESHOOTING
Problem
Possible Causes
Solution
ADD WATER indicator
light is on.
Not enough water to
produce ice.
Turn off the ice maker, fill
it with water, and press the
ICE/CLEAN button again to
restart the ice making
process.
ICE FULL indicator light
is on.
There is too much ice
basket.
Turn off the ice maker,
remove the ice from the
ice basket, and press the
ICE/CLEAN button again to
restart the ice making
process.
No ice cube inside the ice
basket.
Check to see if there is
anything obstructing the
inside of the ice maker or
try drying the interior of
the ice maker.
ICE/CLEAN indicator
light flashes red
Ambient temperature or
water temperature in
inner tank is too high.
Please run the ice maker
below 90 Fahrenheit
degree ambient and pour
colder water into the
water tank.
Refrigerant liquid leakage.
Press the ICE/CLEAN
button twice to restart ice
making process. If this
problem shows up again,
contact customer support.
Cover motor is broken.
Pipe in the cooling system
is blocked.
Making Ice too slowly
Hot Air outlet has been
blocked by something.
Hot Air outlet must be
guaranteed to have more
than 6 inches of ventilation
distance.
Water temperature in
inner tank is too high.
Water temperature
requirement between 7℃-
32℃.
Refrigeration system
malfunctions.
Contact customer support.
Water leakage
Drain plug not installed
properly.
Put the drain plug in place.
It must be secured tightly.
Pipe Joint in the appliance
may Loose
Verify by a qualified
technician.
The seal has reached
service life
Verify by a qualified
technician.

NewAir NIM026MBN0 Specifications

General

Brand	NewAir
Model	NIM026MBN0
Category	Ice Maker
Language	English