NewAir NIM033BK00 User Manual

11
TROUBLESHOOTING
Problem
Possible Causes
Solution
“ADD WATER”
indicator is on.
Water level is low.
Press “ON/OFF,” fill the
water tank, and press
“ON/OFF” again.
“ICE FULL”
indicator is on.
The ice basket is full.
Remove ice from the
basket.
The ice sensor is broken.
Press “ON/OFF” to see if ice
production restarts. If not,
contact customer service.
The ice scoop is stuck.
Check if ice is blocking the
ice scoop and remove the
ice.
Ice cubes stick
together.
The ice making cycle is too
long.
Stop the ice maker and
restart when the current
ice blocks melt and fall off.
Turn the unit back on.
Part of the evaporator rods
in the ice box are too large.
Change the water in the
reservoir.
The water temperature in
the inner tank is too low.
Use colder water to fill the
tank.
Ice is full but the
light is off.
The location of the ice
maker’s light is too strong,
and it effects the infrared
detection.
Move the ice maker near a
darker location.
Ice making cycle
is normal but
there is no ice.
Ambient temperature or
water temperature is too
high.
Try to keep the ice maker
out of heat near 90
degrees, and fill the tank
with cold water.
Refrigerant liquid leakage.
Contact customer service.
The pipe in the cooling
system is blocked.
Contact customer service.
NOTE: Certain noises are normal when operating this ice maker: a clicking
sound when the machine is turned on or off, a bubbling, gurgling, or knocking
sound when refrigerant is circulating through the pipes, or a loud clink sound
when ice cubes are dropped into the basket.

NewAir NIM033BK00 Specifications

General

Brand	NewAir
Model	NIM033BK00
Category	Ice Maker
Language	English