Newall NMS 300 - Default Chapter; Table of Contents

2
Contents
Specication Page 3
Electrical Page 3
Physical Page 3
Environment Page 3
Accreditation Page 3
Disposal Page 3
Input and Resolution Page 3
Mounting Options
Page 4
Mill Mount Page 4
Lathe Mount Page 4
Connection Details Page 5
Important Information Page 5
Connections Page 5
Display and Keypad Page 6
Understanding the Display Page 6
Understanding the Keypad Page 6
Setting up the Unit Page 7
Navigating Complete Setup Page 7
Navigating Complete Setup (Continued) Page 8
Language Setup Page 9
Type Setup Page 9
Encoder Resolution Setup Page 9
Direction of Travel Setup Page 10
Radius / Diameter (Measure Setup) Page 10
Error Compensation Page 10/11
Linear Error Compensation Page 12
Linear Error Compensation Setup Page 13/14
Segmented Error Compensation Setup Page 15/16
Using Segmented Error Compensation Page 17
Plane Setup Page 18
Functions Setup Page 18
Feed Setup Page 19
Brightness Setup Page 19
Beep Setup Page 19
Sleep Setup Page 20
Reset Setup Page 20
Standard Functions Page 21
Absolute / Incremental Page 21
Inch / mm Page 22
Zero and Preset an Axis Page 22
Undo Function Page 23
1/2 Function / Centre Find Page 23
Function menu / function keys Page 24/25
Reference Page 25/26
Sub Datum Memory Page 26/27/28
Feed Rate Page 28
Mill Functions Page 29
Pitch Circle Diameter (PCD) / Bolt Hole Page 29
Line Hole Page 30
Arc Contouring Page 31
Pocket / Island Page 32
Lathe Functions Page 33
Tool Offsets Page 33/34
Taper Turning Page 35
Trouble Shooting Page 36