Need help?Do you have a question about the Newall NMS 800 and is the answer not in the manual?
General| Brand | Newall |
|---|---|
| Model | NMS 800 |
| Category | Digital readouts |
| Language | English |
Electrical specifications, physical dimensions, and environmental operating conditions.
Compliance certifications, disposal guidelines, input types, and resolution specs.
Instructions for standalone mounting the unit.
Instructions for panel mounting the unit.
Crucial safety and connection information.
Diagram and description of unit connections.
Explanation of display elements and indicators.
Explanation of keypad buttons and their functions.
Entering setup, navigating menus, and display settings.
Configuring language, brightness, sleep mode, and axis labels.
General DRO setup and machine type selection.
Plane summing, zero threshold, and mill summing configuration.
Scale factor, beep enable, and feed rate unit setup.
Setting feed rate to minutes or seconds.
Activating various functions.
Configuring tool offset functions.
Using the vector function.
Encoder setup basics and digital type selection.
Rotary mode, digital resolution, and gear ratio configuration.
Quad index, signal check, and display resolution settings.
Zero beep, encoder direction, and measurement mode settings.
Error compensation setup and unit reset.
Choosing the display language.
Adjusting the display brightness.
Configuring the automatic sleep mode.
Redefining axis labels.
Choosing the machine type.
Scaling the DRO to machine travel.
Enabling or disabling audible beeps.
Configuring feed rate units (minutes/seconds).
Activating specific functions.
Selecting the encoder type.
Setting rotary encoder mode.
Setting digital resolution for rotary encoders.
Scaling rotary encoder to equipment.
Enabling/disabling signal comparison.
Activating reference mark (Z).
Setting display resolution based on encoder.
Visual indicator for approaching zero.
Summing axes or planes together.
Placeholder for explanation.
Activating summing of axes/planes.
Matching NMS800 to axis direction.
Displaying radius or diameter.
Improving productivity via error reduction.
Checking DRO system accuracy.
Explaining machine errors like pitch, roll, yaw.
Applying a constant correction factor.
Breaking scale travel into segments.
Automatically calculating linear errors.
Navigating to error compensation.
Continuing teach mode operations.
Manually calculating and entering linear compensation.
Continuing program mode operations.
Resetting unit to default parameters. WARNING.
Listing available functions and their descriptions.
Toggling between absolute and incremental modes.
Displaying position relative to last position.
Displaying position relative to a fixed datum.
Toggling between set/zero modes and axis operations.
Switching between inch and millimeter measurement units.
Assigning functions to keys.
Quickly defining function keys.
How to use assigned function keys.
Digifind overview and setting the reference.
Procedures for recovering lost reference and zero.
Storing up to 200 machining steps.
Storing sub datums using teach mode.
Storing sub datums using program mode.
Deleting all current data in SDM.
Using stored sub datum positions.
Using the feed rate function.
Storing and managing tool offsets.
Setting tool offsets via teach mode.
Setting tool offsets via program mode.
Selecting and using different tools.
Editing/creating tool offsets quickly.
Deleting all tool offsets.
Calculating positions for holes in an arc.
Entering centre, radius, diameter, cut type.
Calculating positions for pocket/island corners.
Entering centre, height, width, tool diameter.
Calculating positions for holes around a circle.
Entering centre, diameter, number of holes, angle.
Showing angular displacement of (X,Z) position.
Troubleshooting blank display, resets, and unresponsiveness.
Solutions for erratic readings, signal loss, and incorrect measurements.
To Next Page