What to do if Newave PowerValue 11 shows OVERLOAD?
If your Newave UPS displays an OVERLOAD message, it means the load exceeds the UPS's rated power. Identify and disconnect the equipment causing the overload. Avoid connecting devices like laser printers, photocopiers, electric heaters, or kettles to the UPS.
How to fix OUTPUT SHORT on Newave PowerValue 11?
If your Newave UPS indicates an OUTPUT SHORT, it means there's a short circuit at the UPS output, on the load side. You should check all output connections and repair them as necessary.
Why does my Newave UPS show MAINS BYP/RECT FAULT?
The MAINS BYP/RECT FAULT on your Newave UPS indicates that the mains power supply is outside the prescribed tolerance. The input power to the UPS might be too low or missing. Verify that the site power is OK and inspect the input circuit breakers supplying the UPS.
What to do if Newave PowerValue 11 UPS shows OVERTEMPERATURE?
If your Newave UPS displays an OVERTEMPERATURE warning, first check that the ambient temperature around the UPS is below 30°C. If the temperature is normal, contact an authorized service center.
What to do if Newave UPS is in BATTERY IN DISCHARGE mode?
If your Newave UPS is in BATTERY IN DISCHARGE mode, it means the battery is near the end of its autonomy. To prevent data loss, shut down the load connected to the UPS before it switches off automatically to protect its batteries.
What causes SYNCHRON FAULT in Newave UPS?
SYNCHRON FAULT in Newave UPS is caused by the frequency of the input voltage to the UPS being outside operational limits, which results in the UPS static bypass being temporarily disabled.
Steps for preparing, connecting, and earthing single-phase input cables.
Connecting the UPS to the mains supply via a single feed.
Preparing and connecting output cables and loads to the UPS.
Steps for preparing, connecting, and earthing three-phase input cables.
Connecting three-phase mains supply, including single and dual feed options.
Procedure for starting up and shutting down the UPS using ON/OFF buttons.
Detailed steps for safely starting up the UPS system.
Step-by-step guide for completely shutting down the UPS unit.
Procedure for transferring the load from inverter to maintenance bypass.
Procedure for transferring the load from maintenance bypass back to inverter.
Identifies common alarms, their meanings, and suggested solutions for fault rectification.
General| Category | UPS |
|---|---|
| Topology | Line Interactive |
| Output Voltage | 230 VAC |
| Capacity | 1000VA / 700W |
| Frequency | 50/60 Hz (auto-sensing) |
| Battery Type | Sealed Lead-Acid (SLA) |
| Communication Interface | USB |
| Input Voltage | 230V ± 25% |
To Next Page
