To Next PageTo Next PageWhat to do if my Newave UPS is showing an OVERLOAD?
If your Newave UPS shows an overload error, identify the equipment causing it and disconnect it from the UPS. Avoid connecting devices like laser printers, photocopiers, electric heaters, or kettles.
Why is my Newave PowerScale displaying a MAINS BYP/RECT FAULT?
If you see a MAINS BYP/RECT FAULT on your Newave UPS, it means the input power is either too low or missing. Verify the site power. If the power seems okay, inspect the input circuit breakers that supply power to the UPS.
What to do if Newave PowerScale UPS shows an OUTPUT SHORT error?
If your Newave UPS indicates an OUTPUT SHORT, you should inspect all output connections and repair any faults you find.
How to fix OVERTEMPERATURE on Newave UPS?
If your Newave UPS is showing an OVERTEMPERATURE warning, first check that the surrounding temperature is below 30° C. If the temperature is normal, assistance from an authorized service center is needed.
What to do if Newave PowerScale UPS is showing BATTERY IN DISCHARGE?
When a Newave UPS shows a BATTERY IN DISCHARGE warning, shut down the load connected to the UPS before it turns off automatically. This protects the batteries.
Introduces manual, scope, and safety precautions for UPS system.
Details essential safety guidelines, warnings, and precautions for operating the UPS.
Guidance on selecting location and positioning UPS and battery cabinets.
Outlines steps and precautions for the electrical installation of the UPS.
Covers operational aspects, including commissioning and control panel usage.
Provides step-by-step procedures for start-up, shutdown, and load transfer.
Outlines user responsibilities, routine maintenance, and battery testing procedures.
Provides info on alarms, event logs, and fault identification and rectification.
Details POWERSCALE UPS system, features, power ranges, and parallel capabilities.
General
