Newave PowerScale - Contents Section-6

Section-6
www.newavenergy.com
04-1206_S6_NW_OPMPS_10-50kVA_GB_110201.doc Page 1/6
Printed in Switzerland – Modifications reserved
CONTENTS SECTION-6
6.1 MULTI-CABINET CONFIGURATION ..........................................................................................2
6.1.1 CONCEPT OF MULTI-CABINET CONFIGURATION ...........................................................2
6.1.2 INSTALLATION INSTRUCTIONS.........................................................................................3
6.1.2.1 Introduction ....................................................................................................................3
6.1.2.2 Paralleling of UPS-Cabinets...........................................................................................3
6.1.2.2.1 Connection of Parallel Communication Cables (BUS-lines).......................................3
6.1.2.2.2 Parallel Adapter and DIP-Switch SW2-2 ....................................................................4
6.1.2.3 DIP-Switch SW1-9 Settings ...........................................................................................4
6.1.2.4 DIP Switch SW1-9..........................................................................................................4
6.1.2.5 ON/OFF – Main Buttons.................................................................................................5
6.1.2.6 Parallel Isolator (IA2)......................................................................................................5
6.1.2.7 Maintenance Bypass (IA1).............................................................................................5
6.1.2.7.1 Redundant Parallel Configuration...............................................................................5
6.1.2.7.2 Capacity Parallel Configuration ..................................................................................5
6.1.2.8 ECO-MODE (BYPASS MODE) in Parallel Systems ......................................................5
6.1.3 COMMISSIONING OF PARALLEL CONFIGURATION ........................................................6
6.1.3.1 Start-up of a Parallel Configuration................................................................................6
6.1.3.2 Shutdown of Parallel Configuration................................................................................6