TO INSTALL THE BATTERY, slide it into the rack under the seat with both hands. The lock
will prevent it going all the way in, so push the key into the lock and turn it anticlockwise.
This will open the lock, allowing you to slide the battery fully into place. With the battery
installed, turn the key clockwise, then remove it and keep it safe. Check the battery is
correctly locked in place by trying to pull it out from the rear of the bike.
TO REMOVE THE BATTERY, push the key into the lock and turn it anticlockwise to unlock
the battery, then pull it backwards from the rear of the bike using your other hand. The
battery pack can be charged when installed in the bike or when it is removed. Removing
the battery reduces the total weight of the bike and may make it easier to lift it up stairs.
14
345
To Next Page
Loading...
