NewLine NT+ Series - Language and Input Settings; Date & Time Settings


Select 'DWH7LPH to enter the setting interface. You can set GDWHWLPH, VHOHFWWLPH
]RQH, KRXUIRUPDW and GDWHIRUPDW in this interface. Press button on remote control
to return to the upper interface.
◆
'DWH7LPH
◆
,QSXWDQG2XWSXW
Select ,QSXW to enter the setting interface of input. You can set 6WDUWLQJ6RXUFH, 1HZ
,QSXW6RXUFH, LQSXW(',', &(& 3RZHU2Q and &(&3RZHU2II in this interface.
Press button on remote control to return to the upper interface.
Ɣ
Ɣ
Ɣ
Ɣ
Ɣ
6WDUWLQJ6RXUFH: Set the signal source entered after power on.
1HZLQSXW VRXUFH: After the function is enabled, the system can automatically
switch to the screen of the newly connected signal source.
,QSXW(',': Set the input EDID to 1.4 or 2.0.
&(&3RZHU2Q: After the &(&SRZHURQ function is enabled and the screen is
connected with the CEC device via the HDMI port, the screen automatically starts if
the CEC device starts and the screen receives a CEC power on command.
&(&3RZHU2II: After the &(&SRZHURII function is enabled and the screen is