21
（
Tips
：
Updated to Q Series Back panel figure
）
2.4 Installing the OPS (Optional)
The OPS does not support hot plugging. Therefore, you must insert or remove the OPS when
the display is powered off. Otherwise, the display or OPS may be damaged.
You will need to purchase the OPS separately. Perform the following steps to install the OPS:
Step 1 Unscrew the M3 screws by hand to remove the OPS protective cover.
Step 2 Slide the OPS into the OPS port on the rear of the panel until firmly seated.
Step 3 Secure the OPS to the display by using the M3 screws.
To Next Page
Loading...
