What to do if Newlong Industrial Equipment leaks oil from ?C?
If your Newlong Industrial Equipment is leaking oil from point ?C, the cause might be a loose plug. Try tightening the plug. If the leak persists, replace the lubricator.
What to do if Newlong Industrial Equipment leaks oil from ?A?
If oil is leaking from point ?A on your Newlong Industrial Equipment, it may be due to a worn-out or displaced seal of the O-Ring. The suggested solution is to replace the lubricator.
What to do if Newlong Industrial Equipment leaks oil from ?B?
If you notice an oil leak from point ?B on your Newlong Industrial Equipment, the issue is likely a worn-out or displaced seal of the packing. The solution is to replace the lubricator.
Why is the button on my Newlong Industrial Equipment not returning?
The button on your Newlong Industrial Equipment might not be returning due to accumulated dust or a broken spring. To resolve this, replace the lubricator.
How to fix full stroke movement not obtainable in Newlong Industrial Equipment?
If you're unable to obtain full stroke movement with your Newlong Industrial Equipment, it could be caused by dust attached to the interior wall of the pumping chamber. Replacing the lubricator should resolve this issue.
How to fix oil not fed in Newlong Industrial Equipment?
If oil is not being fed in your Newlong Industrial Equipment, the cause is likely a low oil level. To fix this, fill the oil.
Lists included accessories for the machine.
Instructions for lubricating the machine before operation.
Guidance on correctly installing the needle.
Steps for threading the machine's needle and thread path.
How to adjust the thread tension for optimal stitching.
Adjusting needle and looper alignment for proper stitch formation.
Common issues and solutions for the lubricator.
General| Type | Portable Bag Closer |
|---|---|
| Stitch Type | Single Thread Chainstitch |
| Needle | DNx1 #25 |
| Motor Power | 90W |
| Thread | Synthetic thread or cotton thread |
To Next Page
