Need help?Do you have a question about the Newport 6155AS and is the answer not in the manual?
Follow safety regulations to prevent electrical or fire hazards and ensure safe operation.
Links W1, W2, W3 configure the module for 230V or 115V AC operation.
Module address, baud rate, and mode are set using DIP switches accessed via the front lens.
Switches S5 and S6 are used to set the baud rate to 9600, 2400, 1200, or 300.
Switches S7 and S8 select the operating mode: Shift, Strobed, 269, or P6000.
Jumper settings are provided for various input signal types like TTL, 2mA Loop, 20mA Loop, ±5V, Diff, and 269.
Details pin assignments for power input (TB1) and signal input (TB2).
Solder switches SW1 and SW2 allow inversion of input data logic polarity for current loops.
To Next Page
General