CONTROLS & SETTINGS
2. 1 Controls:
2.1. 1 Control key board:
EXIT MENU POWER
EXIT: Go back to previous menu, and exit OSD
: Move down/left in the OSD menu. Decrease (-) the value of volume/brightness.
: Move up/right in the OSD menu. Increase (+) the value of volume/brightness.
MENU: Enter into OSD menu and select item for confirming settings.
Power: Turn on/off the display monitor.
Indicator Status
Lit (No): Power off
Lit (Green): Power on
Blinking (Red): Power saving mode
VIDEO SOURCE SELECTION BUTTON
To select the desired signal (" Auto Select "," DisplayPort ", "HDMI 1 ","DVI") press the button "+" and "-" to
select the desired item. Press the button "MENU "to confirm.
3
To Next Page
Loading...
Need help?
General
