Next 792296 - Step Sixteen: Slat Placement; Step Seventeen: Bolt and Cap Insertion; Step Eighteen: Second Single Bed Assembly

1. Insert 8 × bolts(A) and 14 × plastics caps (H) to
the assembled bed frame and using allen key(G) to
tighten.
2. Insert plastic cover 13 (×4) to the assembled bed
poles.
USE ALL REMAINING PARTS TO ASSEMBLE THE
SECOND SINGLE BED
1. Repeat Step Thirteen to Step Seventeen (Note:
side rail 5 & 6 change to side rails 7 (×2).
2. Insert plastic cover 13 (×4) to the assembled bed
pole.
STEP EIGHTEEN
STEP SIXTEEN
STEP SEVENTEEN
1. Attach slats 8(×23) to the assembled unit. A
rubber mallet (not supplied) may be required to
gently tap each slat into the slat locks on each side
of the bed rails.
Page 8 of 9