-Auto Power Off: Default is Off. Press UP and
DOWN button followed by OK to switch it 15,
30 secs, 1min, or Off to disable it.
*A setting of 1 MIN means the camera is ON
but not in use, it will auto turn OFF after 1
minute of inactivity.
-Date Stamp: Default is Date&Time. Press UP
and DOWN button followed by OK to switch it
Date&Time, Date,Off.
-Date&Time: Press UP/DOWN and OK button
to set the current date and time. Press the
OK button to exit.
-Language: Default is English. Press OK to
select between English, Simplified Chinese,
Japanese, German.
-Light Frequency: Default is 60Hz. Press OK
to switch between50Hz/60Hz/Auto.
-Format Card: Press navigate Up and DOWN
button and select OK to format the micro SD
card.
-Default Setting: Press OK and Press Up and
Down button to select Confirm to reset the
device back to stock factory settings.
-SD Info: Press Ok to check the micro sd card
information and capacity.
-System Info: Show the current firmware
version.
Press the MENU button to exit and complete
the setup.
To Next Page
Loading...
