INSTALLING A POINT-TO-POINT (P2P)
(OUTDOOR INSTALLS ONLY)
13
If your outdoor unit’s computer location does not have hardline internet access,
you will need to install a point-to-point (P2P) wireless bridge.
The following video will demonstrate the installation process:
Please be aware of the following requirements:
• DO NOT PLUG INTO A POWERED NETWORK SWITCH. Because these
dishes run on 24V, the 48V supplied by powered network switches can
fry the dish.
• Make sure you connect the cables to the LAN and PoE ports of the
injector BEFORE plugging the injector into an outlet.
• It is recommended to install Side A (transmitting side) before installing
Side B (receiving side).
• Ensure the two dishes have a clear line of sight (i.e. no trees or
bleachers blocking their view)
To Next Page
Loading...