(1) Power Switch - Activates power for subwoofer
(2) AC Power Input - Power cord receptacle.
(3) Subwoofer Input - Input for RCA connector from Controller.
(4) Power Indicator - The light shows green when the system is on, shows red in standby
(5) Standby Indicator - The amber light is lit when the subwoofer is in standby mode.
(6) Power Indicator - The green light is lit when the system is on.
(7) Volume Control - Adjusts the loudness of the subwoofer independently of the main speakers.
(8) Flat / Video Contour Switch - Selects response mode of subwoofer.
(9) LFE Gain Control - Adjusts amount of LFE in the mix
(10) Power Input - To accept power from the LL1 power supply
(11) Subwoofer Phase Selector - 2-position selectable phase control for subwoofer.
(12) Low Pass Filter - Continuously variable low pass crossover control.
(13) LFE Input - Line Level RCA Low Frequency Effects input.
(14) Line In - Line-level RCA input connectors.
(15) Satellite Line Out - Line-level RCA output jacks to receiver / main amplifier.
(16) Output to Satellites - Barrier strip for speaker-level connection to main speakers.
(17) High Level Input - Barrier strip for speaker-level input from receiver / amplifier.
(18) Subwoofer Gain Selector - Allows optional attenuation of SubOne i gain.
(19) High Pass Filter - 3-way selectable high pass crossover for satellite line out.
(20) Subwoofer Output - RCA cable for connection to SubOne i subwoofer.
3
To Next Page
Loading...
