Nibe ACS 45 - Page 28

Select the average outdoor temperatures in this menu.
Caution
It is not possible to set "Stop additional heat"
higher than "Stop heating".
You can also set the time (Filter time) over which the
average outdoor temperature is calculated. If you select
0, the current outdoor temperature is used.
MENU 7.1.10.3 - DEGREE MINUTES SETTING
Cooling auto
Setting option: on/off
Degree minutes are a measurement of the current
heating requirement in the house and determine when
the compressor respectively additional heat will
start/stop.
MENU 7.5.3 - FORCED CONTROL
Here you can force control the various components in
the installation. The most important safety functions
remain active however.
NOTE
Forced control is only intended to be used for
troubleshooting purposes. Using the function
in any other way may cause damage to the
components in your climate system.
ACS 45 | GB28